Picking interior colors. Close match, not perfect, but close enough.  Photos show the colors a bit lighter than they are. 

The photos uploaded out of order but you get the idea. 

First one shows the original door panel. I am searching to try and find the original color for them. 

Second photo shows the new door pane with the door clips installed 

Third one show a coat of clear on the mahogany plywood for the left rear window. 

The fourth and fifth photos show the panel before clear coat applied. 

Safety wiring and cotter keying the important stuff also, cleaned up the vertical stab elevator cable feed through.  

Drilling the holes for the right side panel. You can see why I’m replacing the old ones. This side has some holes, cracks, and dents that, although they were probably caused by grandpa Fritz, just look terrible.  Looks like an antenna might have been mounted by the windshield on this side. Not original so it’s gone. 

Before and after photos:

Old and new panels side by side.

Venturi tube hole. in the original.

Where the windshield meets the new panels.

Check out the wheel pants I this 108-3. Also, that’s a busy paint scheme. 

Before and after left shroud. 

I purchased some aluminum for new panels today. Got lucky when one of our best sheet metal guys was in the same location as me. He offered to cut the new ones for me. He saved me a lot of time and frustration. 

The top three photos are the existing panels. The remainder are the cutting and fitting of the panels. Ran out of time tonight. Will cut the window holes tomorrow. 

I added a photo at the end showing the almost completed horn assembly. 

Old on top of new. Measuring for new panels on new plywood. Will cut out, stain, and install.