Afterwards
Before shot
Oleo Cover
Latest Photos
Random Photo Update
Anchor nut plates in place around window frame
Fitting the instrument panel to verify clearance for the control column.
Checking door fit and clearance.
Installing one of many pulleys.
Temporary installation of the instrument panel to make sure everything fits and doesn’t affect the control column travel.
Side window and wood trim in place.
Another Brake Setup Photo and Fuel Selector Photo
Brake setup with the added parking brake setup
Fuel tank selector setup
Side Rear Window Frames
window and door frames in place
prior to window and door frames being installed.
Clips in place
Pulleys Before and After
Old Hardware
One reason why I am changing out the old hardware. All if not most is at least 70 years old. It’s showing its wear. These are the seat pivot pins. One old and one new. You can see the wear on the pin from pivoting the seat back so passengers can get into the back seat.
Fuel Selector Valve Installation
Installed the fuel selector valve, shaft, and knob. See past posts on cleaning and reassembly of this valve. Univair offers a new valve for $400. This one was locked up, but it works great now. 
Elevator Trim Tab Control
Installed the elevator trim tab control.
Engine Mount Bolts
Two of the four bolts that hold the engine and mount to the rest of the airframe. They sure look small for holding all that weight; 323.5 lbs. plus the propeller and all that torque.
