Fitting the original ash trays.
Seats
Working in the seats so I can get them to the interior guy at work. He will make seat cushions, side panels, and door panels.
Today I cut and fitted the seat back panels and drilled the screw holes.
My borrowed seat for patterns.
Mt seat back piece i made.
Both seat back panels in place.
The white pieces are patterns i made from the borrowed seat for my new cushions.
Door and Side Panels
Finished these by drilling all the holes and making sure the mopar door clips line up and work. They do.
Sent pictures to the guy who will be covering them for me to get an estimate.
Right side door and side panel
Left side door and side panel
Existing Stinson door panel and how this one will look.
The seat borrowed seat in so i can use it as a pattern.
Voltage Regulator
Mounting the regulator to the firewall.
Floor
Fitting the Floor boards. Need to make sure the holes line up with the fasteners under the floor. So all screws are in place and tightened.
Inside the Engine
Door Clips
It’s been a while since I posted photos but I’m still busy working on the Stinson. I paid a visit to the local car upholstery shop this week to pick up door clips. Funny that the same clips used on a Mopar product is the same for this Stinson.
I needed these clips so I could get the door upholstered.
New clips for the new door panels
The old door panel with the holes for these clips
Anodizing Aluminum
after anodizing
prior to removal from the airplane
after anodizing
Engine Cowling
Cooling Baffles
