Designed and printed some bearing covers to keep the paint out.

Wheels, wingtip lights, and fabric strips.

The wheels came back from paint today. They look really good.

I wired the wingtip light.

I cut new fabric hold down strips.

Torque on this wing drag wire should be 90 lbs. This one was loose. I tightened it up and will torque it to 90. I’ll check the rest while I’m at it.

After to come soon. I will chromate it tomorrow.

Flaps. Nothing is tightened down yet until I make sure it’s all good.

New fuel drain. New cables should arrive tomorrow so I’ll install them and the new pulleys, plus the fuel sensor gasket. Getting closer to covering them.

This is $207.84 worth of parts if purchased new. Good thing I found the originals.

Removed the fuel sender to replace the gasket. Checked the sender using an ohm meter to check for resistant change. . Cleaned the tank mounting edge. Cleaned the tank to fuselage grounding strap. Lots done.