As I mentioned in an earlier post I have to replace some hardware holding on the wheel Pant trim pieces. I found some online for a 43-46 ford. They fit a little differently but I think they will work fine.

Top photo shows three of the trim hardware pieces installed in the trim plus the old and new ones.

Middle Photo shows the new trim hardware in the trim.

Bottom Photo show the differences in the hardware.

As it looks today

Their turn to get paint removed.

Cleaning up the second wheel pant and removed pop rivets from the edge supports. Removed the rear support and straightened it out. Ready to properly rivet it in place.

Third photo shows the pop rivets in place.

Fourth photo shows all the pop rivets drilled out and Cleco’s in place.

Last photo shows the beginnings of the crack repair.

A second coat of paint remover on the second wheel pant. This paint is tough.

First wheel pant is clean inside and out. Just needs to be worked over.

Original trim fasteners cleaned up with new nuts. A few fasteners broke coming off so those will be replaced.

I popped out the major dents after getting the pilot’s side paint removed. Doesn’t look too terrible. There will be some repairs required on the underside and a few rivets replaced.

The paint is on backorder for two weeks. So this gives me time to work on other things.

Going to try these to see if they fit.

These hold on the trim pieces. Guessing they used the same style in automobiles of the same period. Anyone know where I can find some replacements?

Working on cleaning up the wheel pants. They are well used with lots of dents and cracks. But with a little work I think they will be fine.