I will be using LEDs but for now they are regular bulbs.

Numbers are on

Now to paint the registration number on the bottom.

7 days to fully crosslink at 77 degrees. I’ll give it an extra few days before I turn it over and do the bottom. The garage is at 65 today but it’s getting colder out.

$700.00 worth of empty containers. Getting ready to paint the other wing, but was short on reducer so had to order some. It’ll be here Wednesday.

Not counting the fabric, to cover they wing from poly brush to Stinson Maroon and Diane Creme is approximately $1300.00.

This unit is a lot cheaper than the Bendix/King KI 300, and it fits nicely in the turn and bank hole with no modifications. It goes for $1,995.00 while the Bendix/King KI -300 lists for $3,950.00. The AV-30 also provides for heading indication on the artificial horizon display.

There’s a lot of history behind this indicator. It was originally developed by Sandia Aerospace as the SAI-340 Quattro, a four-in-one standby instrument that gives you precision Airspeed, Attitude, Altitude and Slip indications, all in an easy to read EFIS presentation. It can also be an excellent safety enhancing addition to your traditional six pack panel. Bendix/King bought the rights to the unit and have marketed it as the Bendix/King KI-300.

Soon after the indicator hit the market, the FAA issued Emergency Airworthiness Directive 2020-18-51, because in their words,

“This emergency AD was prompted by a report of three failed attitude indicator P/N 306171-10 units. Following the initial report, investigation has revealed a total of 54 failed attitude indicator P/N 306171-10 units. Attitude indicator P/N 306171-20 is affected by the same unsafe condition because it is identical to P/N 306171-10. The effect of the failure was erroneous attitude data provided to the pilot and autopilot, if equipped. In some instances, the pilot is unaware that the data is erroneous or unreliable. In other instances, where the aircraft is equipped with multiple displays, the pilot may be provided with conflicting information, but will have no way to determine which display contains the correct data. This condition, if not addressed, could result in aeronautical decision-making based on erroneous attitude information, which may result in loss of control of the aircraft.“

The AD basically states you can’t couple it to an autopilot and you can’t fly IFR, or use it for Night VFR. With no autopilot and no IFR panel, I only need to be concerned with the night VFR limitation. I’m installing it as a reference indicator as I’m keeping the factory original setup for the panel, so it’s not the primary indicator.

The unit would be installed IAW FAA Policy Statement PS-ACE-23-08-R1 Replacement of Vacuum Driven Attitude Indicators in 14 CFR part 23/CAR 3 Airplanes. This document allows for the installation of a replacement vacuum driven gyro with this indicator in the panel slot where the original indicator was removed. This Stinson didn’t have a vacuum driven gyro at the time of manufacture, but a complete system was installed by FAA Form 337 on August 12, 1947. So it will need to go where the turn coordinator is located and the turn coordinator will go to the upper left position if I want to keep it.

Reading further and still on the turn coordinator subject, the FAA released FAA Advisory Circular AC-91-75 which provides the rational for removing the turn coordinator completely from the panel. Their reasoning is:

“Replacing the rate-of-turn indicator will mean losing an easy reference for standard rate turns. However, in today’s air traffic control system, there is little need for precisely measured standard rate turns or timed turns based on standard rate. Maintaining a given bank angle on the attitude indicator for a given speed will result in a standard rate turn. Pilots using this AC to substitute an attitude indicator for their rate-of-turn indicator are encouraged to know the bank angle needed for a standard rate turn.”

All this hinges on my decision to actually install the indicator. I think it will be beneficial to have it in the Stinson as a backup indicator for all the analog indicators.

Jeff