More photos and pictures I left out of the other related posts. I did install five new small compression springs and breakaway compression spring.

New springs all around.

Ready to adjust the breakpoint in the springs.

Different view of the installed tailwheel.

New thrust washer and new thrust plate installed. New tail wheel attach bushings installed where the tailwheel bolts to the fuselage. New Scott springs and links installed, but not adjusted yet.

I need a couple AN960-816 washers and then align the breakpoint on the tailwheel.

New thrust washer installed.

New thrust washer plate installed.

New bushings for the tailwheel attach point.

Tailwheel installed. Now the springs.

Tailwheel installed. Waiting on a couple washers to finish it up.

The Scott 3200 tailwheel was functional, but looked like heck, so I’m overhauling it. After taking it apart , I discovered a few parts were missing while others were worn down.

So I disassembled, cleaned, inspected all the parts, and bought new parts for those missing and worn.

Now I’m reassembling it. I’ve posted some photos for progress up through this afternoon. Parts should arrive Saturday.

Five springs for heavier airplanes. Lots of grease there.

Wheel bearings

Wheel halves.

Old dowel pin worn down

Old and new paw.

Missing the top thrust washer and thrust plate assembly.

New dowel pin installed after using an easy out to remove the worn pin.

Will try red LEDs next.

Lots of small detail work happening now.