One step closer to fabric. Adding the last few cables to it so I can get it covered.  I’m finding there’s a LOT of stuff on a Stinson!

This shows the rudder trim cable attached to the rudder cable. 

This photos shows the other end of the rudder trim cable. 

The original CB panel had auto resetting circuit breakers. To facilitate the re-wiring process I made a temp panel for the newer CB’s so my wire length can be measured. 

Here’s the old and new panels. 

I tried to save the original cover but it is starting to crack.  I found an original new old stock one. 

While waiting on some hardware to finish the cable runs and other things, I started to see if I could polish the engine baffles. The first one seemed to go OK. Will work on the rest now. 

After some polishing

prior to polishing

during the process.

baffle seal is pretty much gone.